A6150 500MHZ Oscilloscope probes for Tektronix and HP Oscilloscope scope with read-out pin, X10, 2 unit + accessories

Introduction: 

The TX6100 series fixed attenuator rate passive probe is only low frequency compensation trim and high frequency compensation trim. Without X1/X10 slide switch. This kind probe specialty is high system bandwidth and low input capacitance. System bandwidth is up to 500MHz. The cable length is up to 1.5M. It has three for high frequency adjustment's hole on the metal box. Only for oscilloscope input capacitance low than 18pF. If you must be for high frequency adjust. The best take it to careerman for assistance.

TX6100 Series

Low Frequency Compensation Adjustment:

High Frequency Compensation Adjustment

The high frequency compensation box cover located near the connector, Use the BNC adapter, connected the probe to a square wave generator operating between 10kHz to 1Mhz, to 1Mhz terminated into 50ohms. The square wave generator rise time should be approximately 125ns, Adjust each control until the leading edge of the waveform is as flat, square and horizontal as possible��

Texas P6100 Series Probes

     TX6100 Series Fixed Attenuator Rate Passive-probe

Model#:	Attenuator	System Bandwidth (3dB)MHz:	System Rise-time(ns)	Compensation Range (pf):	Voltage Max. (V)	Input Res. (M)	Input Cap. (Pf):	GND. Ref:
TX6135	X10	350	1	5-30	600	10	11	X
TX6140	X10	400	0.875	5-30	600	10	11	X
TX6145	X10	450	0.78	5-30	600	10	11	X
TX6150	X10	500	0.7	5-30	600	10	10.8	X

     The package includes:

1) Two 500MHZ Oscilloscope probes with Mini Alligator Clip and ground lead;

2) 2 Screwdrivers;

3) 4 marker bands;

4) 2 tip locating sleeves.

Click the picture to view large picture

Customer Support Phone Number: (408) 329-7985
Customer Support Skype: Aidetech